Custom Console Settings

The following custom settings can be saved to a USB drive:

• Unit of measurement (see Units)
• KCAL Toggle 
• Backlight duration (see Backlight Settings)
• Screen Contrast level
• Auto Pause setting
• USB port setting

To Save Custom Console Settings:

The custom console settings will be saved in an import.cfg file format.

1. Make sure that the USB port on the console is enabled (see USB Port settings).

2. Insert your USB drive into the USB port on the console.

3. Select the SAVE CFG menu option on the firmware menu. The console will begin saving the custom console settings to the USB drive and the word SAVE— will appear in the message banner.

4. If the custom console settings are saved successfully to the USB drive, the word DONE will appear in the message banner.

5. If the custom console settings are not saved to the USB drive, the word FAILED will appear in the message banner. Go to TROUBLESHOOTING.
 

To Import Custom Console Settings:

You can import saved custom console settings from a USB drive to the console.

1. Make sure that the USB port on the console is enabled

2. Make sure that the desired custom console settings file (import.cfg) is saved on your USB drive.

3. Insert your USB drive into the USB port on the console.

4. Select the IMPRT CFG menu option on the firmware menu. The console will begin importing the custom console settings to the console and the word IMPRT— will appear in the message banner.

Tip: You can also use this shortcut to select the IMPORT CFG menu option: Press and hold the BACKLIGHT and STAGE buttons for 3 seconds.

5. If the custom console settings are imported successfully to the console, the word DONE will appear in the message banner.

6. If the custom console settings are not imported to the console, the word FAILED will appear in the message banner. Go to TROUBLESHOOTING.