SC1 Bike - Stages SC1 Online User Guide
Step 1: Install front stabilizer
Equipment required
- 2 x #1 (M10 x 60 mm)
- 4 x #2 (M10)
- 2 x #3 (M10)
- #9 (Front Stabilizer)
- 6 mm hex wrench
- 17 mm box wrench
- Place the bike onto the front stabilizer (#9) with the wheels facing forward and align both bolt holes.
- Insert two (2) of the M10 x 60 mm bolts, with M10 washers, into the bike base and stabilizer, then thread two (2) M10 nuts onto the bolts from below, with M10 washers between the nuts and stabilizer.
- Use a 6 mm hex wrench to tighten the bolts to 20 N⋅m while holding the nuts with a 17 mm box wrench.
