Step 1: Install front stabilizer

Equipment required

• 2x #1 (M10 x 55 mm)
• 4x #2 (M10)
• 2x #3 (M10)
• #9 (Front Stabilizer)

1. Place the bike onto the front stabilizer (#9) with the wheels facing forward and align both bolt holes.
2. Insert two (2) of the M10 x 55 mm bolts, with M10 washers, into the bike base and stabilizer, then thread two (2) M10 nuts onto the bolts from below, with M10 washers between the nuts and stabilizer.
3. Use a 6 mm hex wrench to tighten the bolts to 20 N⋅m while holding the nuts with a 17 mm box wrench.