SC2 Bike - Stages SC2 Online User Guide

Step 4: Install stem stop bolt & replace the nose cap

  1. Reinstall the handlebar stem screw into the handlebar stem through the hole in the frame.
  2. Slide nose cap back in place.
  3. Reinstall the screws on both sides of the nose cap and tighten with the 3 mm hex wrench.

Clockwise from center: A) a 5 mm hex wrench and bolt aligned with the hole on the head tube, B) the nose cone with an arrow pointing towards the head tube, and C) two 3 mm bolts and hex wrenches aligned with the holes on each side of the nose cone.

SEARCH RESULTS FOR:

"term"