SC3 Bike - Stages SC3 Online User Guide

Step 2: Install rear stabilizer

Equipment required

  • 2x #1 (M10 x 55 mm)
  • 4x #2 (M10)
  • 2x #3 (M10)
  • #9 (Rear Stabilizer)
  1. Place the bike onto the rear stabilizer (#9) with the overlapping portion of the step plates facing rearward. Align both bolt holes.
  2. Insert two (2) of the M10 x 55 mm bolts, with M10 washers, into the bike base and stabilizer, then thread two (2) M10 nuts onto the bolts from below, with M10 washers between the nuts and stabilizer.
  3. Use a 6 mm hex wrench to tighten the bolts to 20 N⋅m while holding the nuts with a 17 mm box wrench.

Set back of the bike over stabilizer. Move screws clockwise with hex wrench to tighten hardware.

SEARCH RESULTS FOR:

"term"