Step 17: Remove the rubber band from the power meter & Install the pedals
Equipment required
- #19 (Pedals)
- 15 mm pedal wrench
WARNING: Pedals must be installed correctly on the corresponding crankarm to ensure safety. The user-right pedal is regular-threaded and the user-left pedal is reverse-threaded.
- Remove the rubber band surrounding the power meter housing and the plastic spacer between the band and the reset button.
- Start to install each pedal (#19) by hand as far as possible to avoid cross-threading. Finish by tightening the pedals very firmly using a 15 mm pedal or open-end wrench.
