Visit Stagesindoorcycling.com
Get Support
SEARCH RESULTS FOR:
"
term
"
English
Deutsch
Español
Français
Indoor Console - Stages SIC2 Console User Guide
Indoor Console
/
Stages SIC2 Console User Guide
/
About
/
Installation
Warranty Information
Console Settings
System Settings
Statistics
Config File
Updating Firmware
Checking Firmware
Auto Pause
Battery Levels
Shut down
Display Settings
Custom Display Settings
No Zone Timeout
Stage Average Hold
Previous Stage Metric
Units
Button Brightness
Screen Brightness
Contrast
Pairing Sensors
Cadence Sensor Pairing
Heart Rate Monitor
Power Meter Pairing
Performing a Zero Reset
Ride Profiles
Bike Number
Setting a Bike Number
Riding with the Console
Recording a Ride
Sleep Mode
Results Mode
Ride Mode
Workout (Stage) Mode
No Zone Stage
Warm Up Mode
Getting Started
Console Features
Activate the Console
Display Features
Definitions
About
Specifications
Installation
Safety Information
Device Care
Installation
Caution:
The SIC2 console is compatible with SC3.20 bikes only.
To install the SIC2 Console:
Thread the power harness from the handlebar stem through the console base.
Hand thread the washers (2) and screws (2) into the nuts in the handlebar stem. Tighten the screws using a 3 mm hex wrench.
Insert the connector from the console into the connector from the power harness.
Insert the console into the console base.
Secure the console to the console base. Tighten the screw using a 3 mm hex wrench.
Previous
Next
SEARCH RESULTS FOR:
"
term
"