1. Activate the console by pressing any button and go to the Settings menu.
2. Select Zero Reset. To Select ZERO RESET, press and hold both the BACKLIGHT and AVG/END buttons for 5 seconds. ZERO RESET will appear on the message banner.
Note: In pairing mode, once a power meter is successfully paired with the console, the console will navigate directly to this menu option.
3. Position Power Meter.
IMPORTANT: Zero reset should only be performed when the power meter is installed on the bike.
a. Rotate the power meter at least one revolution to ensure that it is awake and ready to communicate.
b. Position the power meter vertically (6 o’clock), and ensure that there is no load on the pedals and the bike is stable.
Note: If the power meter is moving or is not positioned vertically the zero reset will fail.
4. Perform Zero Reset by pressing the STAGE button. The console will countdown for 60 seconds or until it successfully performs the zero reset.
5. Complete the zero reset process. If the zero reset is successful, the word SUCCESS will appear in the message banner along with a random number below it. The console will then return to the STARTUP mode.
Note: The displayed zero reset value will NOT be zero but rather a number that corresponds to the measurement taken by the sensor. If the zero reset fails, the word FAILED, will appear in the message banner. Go to step 6.
6. Troubleshooting the zero reset process if necessary.
If the zero reset fails, follow these steps:
a. Make sure that fresh batteries are installed in the power meter.
b. Make sure that the console is paired to the power meter. (See Power Meter Pairing.)
c. Make sure that the power meter is in the vertical position (6 o’clock).
d. Repeat zero reset process beginning at step 1.
e. See the Power Meter User Guide or contact customer support.
7. Use the shortcut zero reset process if desired. Follow the steps below to quickly zero reset the power meter without having to enter the setup mode.
a. Rotate the power meter at least one revolution to ensure that it is awake and ready to communicate.
b. Position the power meter vertically (6 o’clock), and ensure that there is no load on the pedals and the bike is stable.
c. Activate the console by pressing any button.
d. Press the STAGE button to enter the WARM UP mode.
e. Press and hold the BACKLIGHT button for 3 seconds.
Note: The zero reset process will begin immediately. Ensure that steps (a) and (b) have been completed.
f. Return to step 5.
